What Happens If You Don’t Clean Your Used Yoni Egg?

Do you want to know how to work with a yoni egg? And how to clean a gemstone egg? Read our yoni egg manual here!

Clean yoni stones

With yonieggs and yoni products it is important that you work with clean stones. That is why you clean the egg for your first session. Then you do that after each use. In addition to a physical bath you can also clean yoni stones energetically. In addition, there are two important rules for a clean Yoni Massage. So in our short hygiene manual you can read everything you need to know. While cleaning a yoni egg this is something that you will have to keep in mind.

Clean yoni egg

You clean a yoni egg with water every time you use it. You obviously do not want to bring in unwanted bacteria. Moreover, gemstone is a natural product and therefore not sterile. There are two easy ways to clean your yoni stone with water:

  • Running water
  • Keep the stone under cold or lukewarm water for about five minutes. Then dry it in the air.

Cooled boiled water

Put your yoni egg for 15 minutes in boiled water that has cooled down slightly. So you sterilize him. Never boil stones and minerals, because then they burst!

Clean and charge Yoni products

Besides a physical bath you can also clean yoni stones energetically . This can help to remove ‘invisible’ dirt such as emotions, tension or thoughts. Then you can recharge the stone so that it has a working power again. You can read more about this in our Basic tips for caring for Gemstones .

Hygienic rules for Yoni Massage

Do not use a yoni egg during menstruation, pregnancy or if you have medical problems around your vagina. In case of doubt, be informed by a doctor or other expert.

Use a new string with each session.

With yoni eggs is often no string. That is because you need a new string every time you use it. You then discard it for hygienic reasons. Make sure you have a piece of string or floss in the house to string through the egg. In the case of floss, use a variant without menthol. You can see why ??

Yoni egg manual

After cleaning and charging you are ready for your very first Yoni Massage ! There is a manual for some massage sets. If you have purchased a separate yoni egg, you will find instructions for use in four steps below:

  • warm up
  • stringing
  • insert
  • remove
  • clean

Warm up

Bring the egg to body temperature. You can do that by placing the stone in lukewarm water for a few minutes. Do not use boiling water with gems!

You can also keep the egg in your body so that it takes over your heat. This is actually the easiest method. Hold it, for example, while you are meditating. Or put it under your clothes against your skin while doing something else. This is actually the easiest and safest method. You can also see it as a relaxed beginning of your yoni ritual.

Stringing

Thread the string or floss through the yoni egg. Always make sure that your rope is long enough so that you can grab it from the outside if you have the egg inside.

If the egg is vertically pierced , make a knot on the convex side.

If you have a yoni egg with a transverse penetration in the top, you string the rope through it. On both sides you let a long piece of rope come out. You can tie the two ends together if you like it.

Insert

Bringing in a yoni egg like all yoni massage with attention and love. And that means taking time! It is all but the intention that you force yourself. Do what you want to do, at your own pace. Actually, that is worth a research: what makes you relaxed? And if you get damp, where does that happen? So do not skip these steps. That way you learn a lot about your wishes and desires. If insertion is physically difficult for you, use a natural lubricant. That is kind to you and your beautiful gem.

Then experiment with slow introduction of the egg. For example, massage your labia first, place it at the entrance of your vagina or spin around it. You often read that a yoni takes the egg by itself. And let go again. I would say: try it out.

Delete

You can remove the egg standing , lying down or squatting . You do not only need the string, but also help from your pelvic floor muscles. So choose an attitude in which you can feel it well. Here too, again: try!

If you want to remove the egg, first use the string. Pull the rope lightly and experience what is happening. Big chance that your egg does not just come out! You need some pressure from your vaginal muscles. Or it is the other way around and you find it difficult to keep your egg inside. In that case you might want to try out a larger size . Also the removal is again a whole experience where you learn a lot about your pelvic floor ??

Clean

Clean your egg and throw away the string.A Yoni egg is a precious egg that can be inserted into the vagina. Then the Yoni egg will do her work there. They help to heal emotional tensions, traumas and blockages while they physically provide stronger muscles of the pelvic floor and make the vagina softer. The eggs are also a godsend after pregnancies.

Why Yoni?

Yoni has been the word for vagina, womb or holy temple in Sanskrit since time immemorial (Chakra is also a Sanskrit word). Furthermore, the word at the same time symbolizes the holy mother or goddess. Already by the first Taoists Yoni eggs from Jade were used to strengthen the muscles around the pelvic floor. They see this area as the source for a healthy and happy life. Jade is known for its purifying and harmonious effect. In Taoism, the vagina is also referred to as the vagina. Beginners are still advised to start with a Jade Yoni egg. Also sexually wearing a gem egg can do a lot. A strong pelvic floor provides more pleasure and feeling during sexual exertions. A trained pelvic floor also helps prevent incontinence.

Size?

A Yoni egg is no bigger than a small chicken egg. They are also available in larger sizes but the practiced women tend to use the smaller variants.

Instructions for use Yoni egg;

Clean the Yoni egg with warm water before use. Do you use the egg for the first time? First boil it sterile in a pan (about 10 minutes)

Touwtje – Especially for beginners it is nice to choose an egg with a hole. Here a string can be pulled through so that it can easily be removed. After a number of times when the trust has grown, you can switch to eggs without a hole.

Is Latex Allergy Avoidable For Some People?

The accompanying explanations are intended to provide users with a general, informative understanding of proteins in latex, and additionally allergies associated with the use of gloves.

What is meant by an antigen and an allergen?

Antigens are every one of the substances that provoke an immune response when they enter the body. This should be possible as complex proteins or carbohydrates. As a result, the lymphocytes are stimulated to produce substances (eg antibodies) which react specifically with antigens.

Allergens are antigens that cause an allergic immune response that is typically transmitted by IgE antibodies. Allergic reactions happen when exposed to very concentrated foreign material over an extended period of time. Potential allergens have no influence on non-sensitized persons.

What are antibodies?                                                                                          

Antibodies are immunoglobulins (Ig). These are proteins produced by plasma cells and lymphocytes. There are 5 classes of antibodies, namely IgA, IgG, IgM, IgD, IgE. IgE affects every single allergic reaction.

How does an allergy begin?

Antigens enter the body, animating B and T cells, which then produce antibodies. The antibodies tie to the pole cells and cause a stepwise part of the pole cells. It releases histamines and other mediators. Manifestations include dilated vessels, decreased circulatory strain, faster heart rate, breathlessness, hives and possible unconsciousness. This is a type I reaction. However, there are additionally type II, III and IV reactions. You would need to know about different types of latex allergy as well.

What does this have to do with latex gloves?

There are many different types of common proteins in latex. Some of these proteins are known to sensitize certain users. The remaining proteins in gloves are suspected to induce Type VI reactions in sensitized users. The issue of sensitization has not been completely clarified, but rather there is a general consensus that an abnormal state of residual protein in the gloves causes sensitization. This incidence varies between people and furthermore from race to race, with the frequency or the wear, as a decisive factor, happening in all cases.

Which protein content is considered “safe”?

Studies by the Rubber Research Institute in Malaysia have demonstrated that 80% of the sensitized users did not demonstrate an allergic reaction to the content of water-soluble proteins below 100 µg/g of the glove material. This examination was conducted by a gathering of health care professionals. Further studies on this point are already in progress.

No, the powders on the gloves has nothing to do with the protein reactions that are described above. The powder is a modified maize starch that is bioabsorbable (converted to glucose when absorbed by the body) and isn’t previously known to cause the type of allergies ordinarily associated with the use of the gloves , However, there is evidence that the powder retains proteins of the host glove and subsequently carries a certain percentage of the remaining proteins of the host glove.

For what reason are reactions more unlikely in powder-free gloves?

The process of removing the powder is a post-processing process, that is, the removal happens only when the glove has been completely made. This is done by a process called chlorination. While the process of chlorination ostensibly serves to remove the powder, it likewise removes a considerable measure of the remaining protein at the same time.

Reducing the residual proteins is the reason why powder-free gloves rarely cause allergic reactions to proteins. Therefore, the powder can not be held responsible as a source of allergic reactions to proteins.

Some methods of removing the powder are just by replacing the powder with another covering, for example, polyurethane or acrylic amid the manufacture of the glove. While removing the powder from the gloves, no more proteins are removed here than with a pre-powdered glove. This can lead to misunderstandings among the end users.

What should be possible to reduce proteins in gloves?

The manufacturing process needs to be extended by one step to reduce proteins. This means the remaining proteins happen to be reduced by intensive washing before the glove is coated with the powder. We were able to reduce the protein content to less than 100 µg/g for pre-powdered gloves compared to the general 200-500 µg/g level in comparable items on the market.

Could the use of nitrile gloves eliminate allergic reactions?

Nitrile material does not contain proteins that are different from latex. Therefore, nobody who is allergic to latex proteins won’t have latex protein allergies when utilizing nitrile gloves. This is an alternative item.

However, wearers of nitrile gloves report allergic reactions that are not due to the proteins but rather are triggered by other antigens in the synthetic material.

What are the possible tests that can be used to determine the protein content?

There are several test methods for proteins and allergies:

Modified Lowry method

This is the only test approved by the US Food and Drug Administration (ASTM 5712-2000). It has a sensitivity to at least 50 µg/g. After that, it can never again be determined.

This is a colorimetric shading restricting test based on shading change as a result of different protein concentrations. This includes extraction of residual aqueous soluble proteins latex items, followed by the centrifugation and the addition of phosphotungstic acids (PTA) to remove the interfering water-soluble things. This protein content is quantified utilizing a standard protein. A spectrophotometric measurement is carried out at a wavelength in the range of 600 to 750 Hz (nm).

ELISA (Enzyme Linked Immunosorbent Assay)

A latex allergy is based on human IgE, which reacts to certain proteins in the latex. However, the ELISA test is based on the IgE of rabbit antibodies that react with all proteins. This test isn’t approved by the American Society for Testing and Materials and furthermore by the US Food and Drug Administration.

The test measures the antigenic protein level. An example is the currently available options is the LEAP test. Here, antibodies are used to tie the special antigenic proteins (rabbit antibodies). The antibodies bound to the proteins then react with an added chemical and a shading development happens, the intensity of which depends on the measure of the antigenic protein.

RAST (Radio Allergo Sorbent Test)

This is a test of the allergenic protein levels of gloves. The test is based on the reaction between the allergenic protein and the antibody (IgE). Unlike LEAP, the antibody here is composed of allergic substances of the human body. The weakness of this test is that the concentrated allergic plasma of the patient affects the outcome and along these lines the relevance of the test.

For more info, visit Laidtex